ADC Campus-REX2 RS - Manual (Page 71)

Chapter 3 - Configuring the REX2
Campus-REX2 RS Interface Card User Manual 59
Viewing the Dynamic Routing Table
The entries in this routing table were dynamically learned by RIP. This table
contains a maximum of 2048 entries. It is accessible from both the Router
Configuration and RIP Configuration screens.
1 From the Router Configuration screen, type then press . Or,
from the RIP Configuration screen, type then press . The
Dynamic Route Table is displayed.
2 Enter any of the following:
• to access the previous screen of the table entries
• to access the next screen of the table entries
• to find a specific table entry; the user is prompted to specify an
IP address for the destination device:
Required format is nnn.nnn.nnn.nnn
Enter Destination IP Address: 51.0.0.0
• to display all entries in a table without pages; this provides you
the capability to capture this information to a file using a terminal
emulation software such as HyperTerminal or ProComm
• to refresh or update the table entries
• to clear all entries from the table
4 ENTER
9 ENTER
DYNAMIC ROUTE TABLE
Total entries: 52
DESTINATION SUBNET MASK GATEWAY ADDRESS HOP TIMEOUT(sec) PORT
60 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
59 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
58 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
57 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
56 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
55 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
54 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
53 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
52 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
51 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
50 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
49 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
48 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
47 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
46 .0 .0 .0 255.0 .0 .0 156.10 .18 .90 2 155 LAN
(P)revious (N)ext (F)ind (E)ntire table
(U)pdate table (C)lear table
(R)eturn (M)ain Menu
TABLE>
P
N
F
E
U
C