CognitiveTPG A776 - Manual (Page 25)

20 Chapter 3: Settng up the Printer
A776 Two-Color Thermal/Impact Hybrid Printer: User Guide A776 UG00001 B 10/06
Sample diagnostic menu and print test for a printer with a serial connection. Ethernet diagnostic printout not shown.
Ethernet parameters can not be changed in the configuration menu.
Paper type can be changed in the configuration menu.
Paper types and grades available:
Type 0 - Monochrome grades
Kanzaki P-310
Type 1 - Two-color grades
Kanzaki P-310 RB
Type 4 - Two-color grades
Kanzaki P-320 BB
Type 5 - Two-color grades
Kanzaki P-320 RB
See the Programming Guide for more information.
Test Printout without imaging
A776 / B789 Diagnostics Form without Imager
*** A776 / B780 – Diagnostics Form ***
Model number : A776-0000
Serial number : 0000000000
Boot Firmware
Revision
: V1.05
CRC : 1A0E
P/N : 189-7760246A
Flash Firmware
Revision
: V1.03
CRC : ADCC
P/N : 189-7760248A
H/W parameters
Flash Memoriy Size
: 2 Mbytes
Flash Logos/Fonts : 1024 kbytes
Flash User Storage : 64 kbytes
Flash Journal Size : 64 kbytes
SRAM Size : 512 kbytes
Head setting : D
Paper Type setting : Type 0, Monochrome
Color Density Adj : n/a
Print Density (Mono) : 100%
Max Speed : 180 mm/sec
Max Power : 55 W
Paper Low Sensor : Enabled
MICR : Enabled
MICR Dual Pass : Disabled
MICR DC offset : 80
Check Flip : Disabled
Slip Normal Alignment : 0Dh/13d
Compressed Alignment : 0Ch/12d
Comm. Interface
RX Buffer Size
: 4096
Interface type : RS232/USB
Parameters
Baud Rate
: 115200
Data Bits : 8
Stop Bit : 1
Parity : NONE
Flow Control : DTR/DSR
Reception Errors : Ignore
USB Driver Type : RS232 Emulation
Resident Code Pages : 437, 850, 852. 858
860, 863, 865, 866
1252, 862, 737
Logo(s) defined : NO
User Char(s) defined : NO
Journal Unused : 64 kbytes
To enter Printer Config Menu :
1) Flip DIP switch #1 down
2) Reset the printer, while holding
the Paper Feed button down