CognitiveTPG A776 - Manual (Page 27)

22 Chapter 3: Settng up the Printer
A776 Two-Color Thermal/Impact Hybrid Printer: User Guide A776 UG00001 B 10/06
Printer and imager configurations
Printers are shipped with all the functions and parameters pre-set at the factory, but you can change these settings
manually. The instructions for accessing the menu appear on the bottom of the test printout receipt.
CAUTION
Be extremely careful changing any of the printer
settings to avoid possibility of changing other settings
that might affect the performance of the printer.
The following functions and parameters can be changed
in the scrolling configuration menu, except for those
marked with an asterisk (*):
Communication Interface
RS-232C serial interface
Universal serial bus (USB)
Ethernet* (cannot be set -see next page 27)
RS-232C serial interface settings
Baud rate
Data bits* (fixed at 8)
Stop bits* (fixed at 1)
Parity
Flow control
Hardware (DTR/DSR) or
Software (XON/XOFF)
Data reception errors
Alternate DTR/DSR
Diagnostic Modes
Normal
Datascope
Receipt test
Slip test
MICR test
Check flip test
•
•
Emulation/software options
Printer emulations
A776 native
A756 emulation
Printer ID
Receipt Options
Default lines per inch
Carriage return usage
Default font
Font size
Slip options
Hardware options sub-menu
Print head setting
Paper type
Color density
Print density (mono)
Power supply wattage (max power)
Alternate reset feature
Paper low sensor
MICR
MICR dual pass option
Imaging (see Programmer’s Guide)
•
•