CONTREX CXB2040 - Manual (Page 37)

CXB1525 and CXB2040 MANUAL
8900 Zachary Lane N., Maple Grove, MN 55369 U.S.A. 34
POT/DIP-SWITCHES AMP1 AMP2 AMP3 AMP4 AMP5 AMP6
TACH J3-C to J3-F (S)
SIG. 1 J3-A to J3-F (S)
SIG. 2 J3-B to J3-F (S)
COMP J3-D to J3-F (S)
CURRENT LIMIT J3-E to J3-F (S)
Signal input to Tach ratio:
_V Signal / _V Tach
LIMIT(PULL UP/DN)
S2-8
INHIBIT(PULL UP/DN)
S2-7
RESET(PULL UP/DN)
S2-6
LIMIT(ACTIVE HI/LOW)
S2-5
INHIBIT(ACTIVE HI/LOW)
S2-4
RESET(ACTIVE HI/LOW)
S2-3
MTR TEMP(ACTIVE HI/LOW)
S2-2
+15/+5
S2-1
6.4 CALIBRATION-SETUP RECORD:
It is good practice to keep a record of all pot settings. Doing so will facilitate calibration on future
units and repair on this unit. Although not a substitute for the calibration procedure, it will at least get you
"in the ballpark." Remove the power and allow all capacitors to discharge before taking measurements.
Note: The balance pot should not be measured in this fashion, set per step 4 in the calibration procedure.
Date data taken: / / Serial number S/N:______________
Model number CXB_____________________________________