Controlled Products Systems Group AE-500 - Manual (Page 19)

19
Wireless Transmitter Programming
Up to 500 wireless transmitters can be used with the system. Transmitters can
be ordered in pre-programmed blocks of sequential ID codes. Up to 16 blocks of
transmitters can be used. Transmitter blocks can be ordered with a Facility Code
of 1-15 for block identifi cation if desired. Using Facility Codes is optional. For
security, an individual transmitter can be deactivated in case it is lost or stolen.
✦ NOTE: Transmitters will activate Relay Channels “A” or “B” depending on
the setting of the transmitter button options. See Transmitter Button Setup
(PPN #44) in the System Options section of these instructions.
Assign Block Transmiiter
Assigning a transmitter block assigns memory space for each block of
transmitters used with the AE-500.
✦ NOTE: When a block of transmitters is assigned, all transmitters in the
block will become active and ready to use.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press
3. Enter the number of transmitters in the block.
4. Press
5. Enter the transmitter block’s facility code.
✦ NOTE: Facility codes are optional. Enter 0 to have the system ignore the
transmitter block’s facility code.
6. Press
7. Enter the fi rst (lowest) transmitter ID number for the block of transmitters.
8. Press
9. Exit Programming Mode if all programming is complete.
Assign Single Enrolled Transmitter
Assigning a transmitter allocates memory space for the transmitter
✦ NOTE: When a transmitter is assigned, it will become active and ready to
use.
1. If not already in Programming Mode, connect by telephone or use the local
keypad. Enter the master password and access programming.
2. Press
3. Enter the transmitter facility code (enter 0 if not used).
4. Press
5. Enter the transmitter ID number of the transmitter
6. Press
7. Exit Programming Mode if all programming is complete.
Suspend a Transmitter
Transmitters may be suspended if necessary (such as when a transmitter is lost
or stolen).
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press
3. Enter the transmitter’s facility code (enter 0 if not used).
4. Press
5. Enter the transmitter’s ID number.
6. Press
7. Exit Programming Mode if all programming is complete.
Activate a Transmitter
If a transmitter has been suspended, it can be activated again with these
programming steps.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Press
3. Enter the transmitter’s facility code (enter 0 if not used).
4. Press
5. Enter the transmitter’s ID number.
6. Press
7. Exit Programming Mode if all programming is complete.
PPN 41
41#NUMBER#FC#ID#
NUMBER = NUMBER OF TRANSMITTERS IN THE BLOCK
FC = FACILITY CODE 0-15 (0 IF UNUSED)
ID = LOWEST TRANSMITTER ID NUMBER IN THE BLOCK
ASSIGN BLOCK TRANSMITTER
PPN 42
42#FC#ID#
FC = FACILITY CODE 0-15 (0 IF UNUSED)
ID = TRANSMITTER ID NUMBER
ACTIVATE A TRANSMITTER
PPN 43
43#FC#ID#
FC = FACILITY CODE 0-15 (0 IF UNUSED)
ID = TRANSMITTER ID NUMBER
SUSPEND A TRANSMITTER
PPN 45
45#FC#ID#
FC = FACILITY CODE (0 IF UNUSED)
ID = TRANSMITTER ID NUMBER
ASSIGN SINGLE ENROLLED TRANSMITTER