Entry system mounting (continued) – Controlled Products Systems Group AE-500 User Manual
Page 8
8
Entry System Mounting (Continued)
Recessed Mounting
The cabinet can be mounted recessed using the accessory trim-ring
(P/N ACP00908). The trim-ring mounts in the wall and the cabinet
attaches to the trim-ring.
1. Identify the location of any studs in the wall.
2. Cut a 13” high by 11” wide rectangular hole between studs at the
mounting location.
3. Install any additional mounting material required to provide
surfaces inside the wall 11” apart for attaching the trim-ring.
4. Place the trim-ring in the wall hole. Check for level, then attach the
trim-ring with up to six screws into the side tabs.
5. Drill 3/16” holes in the cabinet’s six pre-marked locations.
✦ CAUTION!: After drilling, remove any metal chips from the
inside of the cabinet.
6. Route the wiring through the trim-ring and into the cabinet through
the center wiring hole.
7. Attach the cabinet to the trim-ring using self-tapping screws
supplied.
8. Replace the circuit board and plug in each wiring connector. Be
sure to replace the green ground wires.
Pedestal Mounting
The cabinet can be mounted on a standard goose-neck pedestal. When
mounting to a pedestal, use the cabinet reinforcing plate to stiffen the
cabinet.
1. Install the pedestal at the desired location.
2. Place the reinforcing plate inside the cabinet.
3. Use security hardware to attach the cabinet and reinforcing plate
to the pedestal.
4. After routing the wiring into the cabinet, replace the circuit board
and plug in each wiring connector. Be sure to replace the green
ground wires.
PEDESTAL
ALIGN THE REINFORCING PLATE
ON THE INSIDE OF THE CABINET
USE SECURITY HARDWARE
TO ATTACH THE PLATE AND
CABINET TO THE PEDESTAL
PEDESTAL
MOUNTING
11"
13"
MARK HOLE LOCATION
4
INSTALL ANY SHIMS TO
ALLOW MOUNTING AND
ATTACH THE TRIM-RING
WITH UP TO 6 SCREWS
5
6
DRILL 3/16" HOLES IN
THE CABINET AT THE
PRE-MARKED LOCATIONS
ATTACH THE CABINET TO
THE TRIM-RING WITH
SELF-TAPING SCREWS
DETERMINE LOCATION FOR
THE 11" x 13" MOUNTING HOLE
3
CUT MOUNTING HOLE
1
2
RECESSED
MOUNTING