Controlled Products Systems Group AE-500 - Manual (Page 24)

24
System Utilities
Several utility commands are available for the system. Utilities can be used to clear
memory, display system information, and control the relays.
Display Unit Number
In multi-unit installations the unit number of each AE-500 can be displayed.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Press
3. The display will show the unit number for three seconds.
4. Exit Programming Mode if all programming is complete.
Display System Firmware Version
The version of the fi rmware installed in the system can be displayed.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Press
3. The display will show the fi rmware version.
4. Exit Programming Mode if all programming is complete.
Manual Control of the Relays
For servicing or testing, each relay output can be controlled manually from the
local keypad while in Programming Mode.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Enter a command to control a relay:
• Press to latch Relay Channel “A”.
• Press to latch Relay Channel “B”.
• Press to release Relay Channel “A”.
• Press to release Relay Channel “B”.
3. The display will show the unit number for three seconds.
4. Exit Programming Mode if all programming is complete.
Deleting Database Entries
Sections of the database can be deleted individually. Exercise care when using
these commands, their effect cannot be reversed.
1. If not already in Programming Mode, connect by telephone or use the
local keypad. Enter the master password and access programming.
2. Enter a command to delete database sections:
• To delete all resident data:
• To delete all entry codes press:
• To delete all wireless transmitters press:
3. Exit Programming Mode if all programming is complete.
Total Memory Reset
This command will erase all data and restore the factory settings.
1. If not already in Programming Mode, use the local keypad to enter the
master password and access programming.
2. Press:
3. Exit Programming Mode if all programming is complete.
PPN 73
73#
DISPLAY SYSTEM FIRMWARE VERSION
PPN 72
72#
DISPLAY UNIT NUMBER
PPN 81
81#
LATCH RELAY CHANNEL "A"
PPN 82
82#
LATCH RELAY CHANNEL "B"
PPN 83
83#
RELEASE RELAY CHANNEL "A"
PPN 84
84#
RELEASE RELAY CHANNEL "B"
PPN 92
92#000000#000000#
DELETE ALL RESIDENT DATA
PPN 93
93#000000#000000#
DELETE ALL ENTRY CODES
PPN 94
94#000000#000000#
DELETE ALL WIRELESS TRANSMITTERS
PPN 200
200#000000#000000#
TOTAL MEMORY RESET