Multichannel Systems LTP-Director Manual - Manual (Page 70)

LTP-Director Manual
66
6.2.2 Control Window Analysis Mode
In the control window it is possible to navigate between experimental phases and sweeps,
and to adjust the detection threshold for the individual electrodes. Data can be analyzed
sweep by sweep, using the arrow buttons, or the whole data file can be analyzed at once
with the "Analyze" button.
The blue window pane on the left side of the main window in analysis mode includes the
command buttons for analyzing the recorded data sweep for sweep with sweep navigation
or in running progression with "Analyze" button. You are able to switch between the phases
of the experiment, and you can change the detection parameters for the up to four selected
electrodes. When the analysis has finished you are able to create a "Report" sheet.
Analysis
After adjusting the detection levels (see paragraph "Detection" below) and selecting a parameter
to analyze (see the drop down menus in "Parameter Display"), press the "Analyze" button.
One parameter is displayed at a time, but all parameters are analyzed. The LTP-Analyzer will
analyze the complete data file. The progress of analysis is shown in the status bar below.
To stop the analysis, click "Cancel".