Multichannel Systems STG4002 Manual - Manual (Page 12)

Stimulus Generator 4002 Manual
8
3.3 Driver Installation
The stimulus generator is a plug and play device. The driver is automatically installed together
with the MC_Stimulus II program.
The Microsoft Windows ® operating system detects a new hardware when the stimulus generator
is connected to the computer, if the program has not been installed beforehand. Simply
cancel the driver installation and proceed with the installation of the MC_Stimulus II program.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, it is possible that the installed hardware does not work properly.
If there are any problems, and you need to install or update the driver manually, please see
the MC_Stimulus II help for more information.
3.4
Installing the Software
System requirements
Software: One of the following Microsoft Windows ® operating systems is required: Windows 7,
Vista or Windows XP (English and German versions supported).
Hardware: USB port (2.0 High Speed)
Installing the software
Please check the system requirements before you install the software. MCS cannot guarantee
that the software works properly if these requirements are not fulfilled.
Important: Please make sure that you have full control over your computer as an administrator .
Otherwise, is possible that the installed software does not work properly.
1. Double-click Setup.exe on the installation volume. The installation assistant will show up
and guide you through the installation procedure.
2. Follow the instructions of the installation assistant. Please select the appropriate maximum
number of analog output channels according to the connected STG. If you have different
STGs in use, choose the highest number.
For the devices with internal stimulation, STG3008-FA and MEA32-STIM4 separate manuals
are available.
After finishing the installation of the MC_Stimulus II software and the STG driver,
you can operate the STG.