Athena Technologies PLATINUM C10 - Manual (Page 23)

22
4 - Operations
4.4 PARAMETER SETTING
A
The parameter setting procedure
has a timeout. If no keys are
pressed for, at least, 30 seconds,
the controller switches back, auto-
matically, to the operator mode.
After having selected the parame-
ter or the code, press
S and G
to display or modify the value (see
pag. 20) The value is entered when
the next parameter is selected, by
pressing the
R key.
Pressing the Q key, the next
group of parameters is present-
ed on the display.
Values
modification
Modification/
selection
entry
Parameter
menù
selection
A2s.p
p.b.
t.i.
t.c.
t.d.
AIs.p 274.8
P 0
P 5:0
P 5:0
P 1:00
P 20
P 0
5000
OK
PASS
Back to the
Operator mode
Operator mode 1st GROUP
AL1 alarm threshold [1]
(see pag. 24)
AL2 alarm threshold [2]
(see pag. 24)
Proportional band
(PID algorithm only)
0.5…999.9% of span
Integral time
(PID algorithm only)
0ff / 0.0 ...100.0 min.
Derivative time
(PID algorithm only)
0ff / 0.01 ... 10.00 min.
Cycle time
(PID algorithm only)
1 ... 200 sec.
Note
[1] It is presented only if the controller has been
configured with 2 alarms. Digit L of the con-
figuration code is assigned to 4 or 5
[2] It is not presented if the controller has been
configured with alarm n° 2 not active or of
sensor break type. Digit N of the configu-
ration code is assigned to 0 or 1.
[3] If password is 0000 to 4999, parameter set-
ting will be available to the operator with-
out entering this password number. If pass-
word is 5000 to 9999, parameter setting
will only be available by entering this pass-
word number.
Password entry [3]
only if
Code value
≥
5000
(see pages 26…27)
Code entry [3]
from 5000 to 9999
Must be equal to the
value of the parame-
ter
Code
YES NO