Athena Technologies PLATINUM C10 - Manual (Page 27)

26
4 - Operations
4.6 CONFIGURATION
The configuration of the controller
is specified through a 4 digit code
that defines the type of input, of
control output and of the alarms.
(sect. 3.2 pag16)
Other parameters specifie the type
of auxiliary functions.
Press
S or G to display the next
parameter or the next code and
change its value.
The new value entered is stored
into the controller when the next
parameter is selected by pressing
R.
Values
modification
Modification/
selection
entry
Parameter
menù
selection
274.8
OK
sc.lo baud
retr
prot
AIs.p PASS
Code
sc.Hi
5000
C ONFIGURATION MENU
1st GROUP Operator mode
Low range [2]
(linear scale only)
-999…9999
High range [2]
(linear scale only)
-999…9999
Communication protocol
(only if communication is
installed)
M.bu5 / jbus
Baude rate
(only if comm. is installed)
1200/2400
4800/9600
Retransmission range
(only if present)
0=20 / 4=20 mA
Password [3]
0…9999
(
33 default from factory)
YES NO
Password entry [3]
only if
Code
value
≥
5000
Code entry [3]
from 5000 to 9999
Must be equal
to the value of the
parameter
Code