Alpine DVA-7996 - Manual (Page 47)

45
-EN
1
p
7
8
6
5
9
4
3
2
Operating the Navigation (sold
separately)
1 NAV. transmission indicator
The transmission indicator lights for few seconds when
the mode selector switch is set to the “NAV.” side.
2 DTR (DETOUR) Button
Automatically recalculates route if a road block or traffic
congestion is encountered.
3 LIST Button
Displays list of the streets currently set for the route. To
return to the guidance mode, press the DISP button.
4 DEL DEST. Button
Deletes current destination.
5 N/H Button
Toggles between North UP and Heading UP
orientation.
6 CANC. Button
Cancels current display screen and switches back to
previous screen with menus.
7 SCALE UP/DN Buttons
8
VOICE Button
Initiates vocal instruction for next route maneuver or
repeats last instruction.
9 MODE Button
Press this button to input numerals using the numeric
keypad, DEL. and +10 buttons.
After pressing the MODE button, the following buttons
will be pressed while the status indicator is blinking:
numerals (0-9), DEL. and +10.
p Mode change switch
Set this switch to the “NAV.” side to operate a
connected Alpine navigation system.
Operating a sold separately TV
monitor
•
To operate a separately sold Alpine TV monitor, press
the mode change switch on the rear of the remote control
unit. Operate while the transmission indicator is blinking.
•
Included remote control unit operation seal: Apply the
seal for the type of TV monitor you are using to the rear
of the remote control unit.
NOTE
Operation may differ or may not be possible for some products.
Also refer to the product’s operating instructions.
(Rear of the Remote Control)