Alpine DVA-7996 - Manual (Page 58)

56
-EN
● Mounting the remote control holder
•
If the remote control is in direct sunlight, remove it
from the holder and keep it in the glove box.
•
When the holder cannot be mounted securely with
Velcro tape, mount it by using screws.
Protective paper
Remote Control
Remote Control
Holder
Console Box etc.
Installation and Connections
Reinforcement Screws
Installation
Caution
When you install this unit in your car, do not remove the
Detachable Front Panel.
If the Detachable Front Panel is removed during installation, you
might press too hard and warp the metal plate that holds it in place.
Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
1
Slide the mounting sleeve into the dashboard.
2
Reinforce the head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (
∗
) already attached to the
vehicle's chassis.
NOTE
For the screw marked ** , use an appropriate screw for the
chosen mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the DVA-7996. Connect all other leads of the
DVA-7996 according to details described in the
CONNECTlONS section.
Metal plate
Detachable
Front panel
Mounting Sleeve
(Included)
Dashboard
DVA-7996
Slide the DVA-7996 into the dashboard. When the unit is in
place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on the
unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
NOTE
Secure the ground lead of the unit to a clean metal spot using a
screw (
∗
) already attached to the vehicle's chassis.
3
Lock Pin
Mounting Bracket
Ground Lead
Screws (M5 × 8)
(Included)
DVA-7996
∗
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
∗∗
∗
DVA-7996
Screw
Air ventilation hole
<DVA-7996 Rear side>