Asus Terminator 2 Barebone System T2-R - Manual (Page 30)

30 Chapter 2: Basic installation
Unplug the power cord before adding or removing expansion cards.
Failure to do so can cause you physical injury and damage the
motherboard.
2.7 Installing an expansion card
In the future, you might need to install expansion cards. The motherboard
has one PCI and one Accelerated Graphics Port (AGP) slot. The following
sub-sections describe the slots and the expansion cards that they support.
For Commercial Deluxe models, a 3-in-1 PCI card is pre-installed in
the PCI slot. You may refer to this section when installing a different
PCI card on the PCI slot.
2.7.1 Expansion slots
PCI slot
The PCI slot supports PCI cards such as a LAN card, SCSI card, USB
card, and other cards that comply with PCI specifications.
AGP slot
The AGP slot supports AGP 8X (+0.8V) cards and AGP 4X (+1.5V) cards.
When you buy an AGP card, make sure that you ask for one with +0.8V or
+1.5V specification.
Install only +0.8V or +1.5V AGP cards. The P4P8T motherboard does
not support 3.3V AGP cards.
If installing the ATi 9500 or 9700 Pro Series VGA cards, use only the
card version PN xxx-xxxxx-30 or later, for optimum performance and
overclocking stability.
P4R8T ®
P4R8T Accelerated Graphics Port (AGP)
Keyed for 1.5v