Asus Terminator 2 Barebone System T2-R User Manual
Page 88
88
Chapter 5: BIOS setup
To recover the BIOS from the support CD:
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
3.
Place the support CD in the optical drive. The support CD contains
the original BIOS for this motherboard.
4.
When the BIOS update process is complete, reboot the system.
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
Floppy not found!
Checking for CD-ROM...
CD-ROM found.
Reading file “p4r8t.rom”. Completed.
Start flashing...
DO NOT shut down or reset the system while updating the BIOS!
Doing so can cause system boot failure!
The system automatically checks the CD-ROM if there is no floppy disk
in the drive.
The recovered BIOS may not be the latest BIOS version for this
motherboard. Visit the ASUS website (www.asus.com) to download the
latest BIOS file.
Make sure that the optical drive is set as secondary master device
when recovering the BIOS using the support CD.
1.
Boot the system.
2.
When a corrupted BIOS is detected, the following screen message
appears.