Asus Terminator 2 Barebone System T2-R - Manual (Page 37)

37 ASUS Terminator 2 barebone system
2.10 Re-installing the power supply unit
Re-install the power supply unit (PSU) after installing the system
components and reconnecting the cables.
To reinstall the PSU:
1. Connect the 4-pin 12V and the
20-pin ATX power plugs to the
ATX12V and ATXPWR
connectors, respectively. See
page 77 for the location of these
connectors.
2. Position the PSU over the
chassis.
3. Align the PSU side hook with the
metal slot on the side of the
optical drive bay.
4. Slide the PSU toward the
direction of the rear panel until it
fits in place.
2
3
4
5. Secure the PSU with the screw
you removed earlier.
5
Make sure the PSU cables
do not interfere with the CPU
and/or chassis fans.
1
1