Asus Terminator 2 Barebone System T2-R - Manual (Page 36)

36 Chapter 2: Basic installation
6. Re-install the HDD tray and
HDD inside the chassis by
loching the tray slots to the
chassis hooks.
7. Secure the tray with the screw
you removed earlier .
8. Connect one end of the 40-pin
IDE cable to the IDE connector
on the drive.
9. Connect a 4-pin power plug
from the power supply unit to
the HDD power connector.
10. Connect the other end of the
IDE ribbon cable to the primary
IDE connector (blue connector
labeled PRI_IDE) on the
motherboard. See page 76 for
the location of the primary IDE
connector.
6
7
8
9