Bosch MUM56S40 - Manual (Page 21)

Robert Bosch Hausgeräte GmbH 21
Protection from overload Fig. 
To prevent serious damage to your appliance if
the continuous-feed shredder is overloaded, the
drive shaft of the continuous-feed shredder has
a notch (predetermined breaking point). If an
overload occurs, the drive shafts breaks at this
point.
A new disc holder with drive shaft is available
from customer service.
Reversible slicing disc – thick/thin
for slicing fruit and vegetables.
Process at setting 5 (3).
Designation on the reversible slicing disc:
“1” for the thick slicing side
“3” for the thin slicing side
t~кебеЦ>
qЬЙ=кЙоЙклбДдЙ=лдбЕбеЦ=ЗблЕ=бл=езн=лмбн~ДдЙ=Сзк=лдбЕбеЦ=
Ь~кЗ=ÅÜÉÉëÉI=ÄêÉ~ЗI=кзддл=зк=ЕЬзЕзд~нЙK=päáÅÉ=
ÄçáäÉÇI=п~су=йзн~нзЙл=зеду=пЬЙе=нЬЙу=~кЙ=ÅçäÇK
Reversible shredding disc –
coarse/fine
for shredding vegetables, fruit cheese, except
for hard cheese (e.g. Parmesan).
Processing at setting 3 (2) or 4 (3).
Designation on the reversible shredding disc:
“2” for the coarse shredding side
“4” for the fine shredding side
t~кебеЦ>
qЬЙ=кЙоЙклбДдЙ=лЬкЙЗЗбеЦ=ЗблЕ=бл=езн=лмбн~ДдЙ=
Сзк лЬкЙЗЗбеЦ=åìíëK=pÜêÉÇ=лзСн=ЕЬЙЙлЙ=пбнЬ=нЬЙ=
Ез~клЙ=лбЗЙ=зеду=~н=лЙннбеЦ=T=EQFK
Grating disc – medium-fine
for grating raw potatoes, hard cheese
(e.g. Parmesan), cooled chocolate and nuts.
Process at setting 7 (4).
t~кебеЦ>
qЬЙ=Цк~нбеЦ=ЗблЕ=бл=езн=лмбн~ДдЙ=Сзк=Цк~нбеЦ=лзСн=
ЕЬЙЙлЙ=~еЗ=ЕЬЙЙлЙ=ëäáÅÉëK
Potato fritter disc
for grating raw potatoes for rostis and
potato fritters, for cutting fruit and vegetables
into thick slices.
Grating: Process at setting 7 (4).
Cutting: Process at setting 5 (3).
Working with the continuous-feed
shredder
Fig.

 Press the Release button and move
the swivel arm to position 2.
 Insert the bowl:
– Tilt the bowl forwards and then set
it down.
– Turn anti-clockwise until it locks
into place.
 Press the Release button and move
the swivel arm to position 3.
 Remove drive cover from the drive
of the continuous-feed shredder (Fig.
-5a).
 Hold disc holder at the lower end, ensuring
that the two tips are face up.
 Carefully place the required slicing or
shredding disc onto the tips of the disc holder
(Fig.
-6a). In the case of reversible discs,
ensure that the required side is face up.
 Grip disc holder at the upper end and insert
into the housing (Fig.
-6b).
 Attach the cover (note mark) and rotate all
the way in a clockwise direction.
 Place continuous-feed shredder on the drive
and rotate all the way in a clockwise
direction, as illustrated in Fig.
-8.
 Turn rotary switch to recommended setting.
 Put food to be processed in the feed tube
and push down with the pusher.
t~кебеЦ>
mêÉîÉåí=нЬЙ=Емн=беЦкЙЗбЙенл=Скзг=ДмбдЗбеЦ=мй=
бе нЬЙ=змндЙн=çéÉåáåÖK
Tip: To ensure even cutting results, process thin
ingredients in bunches.
Note: If the food to be processed sticks in
the continuous-feed shredder, switch appliance
off, pull out mains plug, wait until the drive
comes to a standstill, remove cover from the
continuous-feed shredder and empty feed tube.
After using the appliance
 Switch off the appliance with the rotary switch.
 Rotate the continuous-feed shredder in an
anti-clockwise direction and remove.
 Rotate the lid in an anti-clockwise direction
and remove.
 Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig.

).
 Clean parts.
en