General Pump MK Repair Manual - Manual (Page 11)

GENERAL PUMP
A member of the Interpump Group
MK SERIES
Remove the crankshaft with the help of a hammer on the PTO side (1, fig. 28). Remove the shaft and the
bearing (1, fig. 29).
If the replacement of one or more connecting rods or plunger guides is necessary, please operate as follows:
Unfasten the screws of the tool (p/n 27566200 to unlock the connecting rods (1, fig. 31) and therefore
extract the connecting rod-plunger guide units from the opening behind the crankcase (1, fig. 32).
On the opposite side, extract the bearing (1, fig. 30)
Page 11