Setup, Unpack the accessory kit, Assemble the dye bottle and oil bottles – Robinair 34988 Recovery, Recycling, Recharging Unit User Manual

Page 7

Advertising
background image

5

554228 Rev. E July 30, 2013

Setup

Figure 1

Important: To operate this equipment,
the owner must complete and mail
the MVAC Certification Form, and
technicians must be certified with the
Environmental Protection Agency (EPA).

Unpack the Accessory Kit

Unpack the accessory kit from the box, and
remove the plastic packaging. The kit consists of
• A calibration weight.
• Vacuum pump oil, oil filler cap, and tube.
• Service hoses.
• Four bottles—oil reservoir, oil drain, UV dye

reservoir, spare reservoir.

• Three rolls of paper for the printer.
• Plastic pouch containing a warranty card (to be

completed and mailed), applicable MSDS sheets,
a service center listing, and an envelope of Mobile
Air Conditioning Society (MACS) information.

Assemble the Dye Bottle and Oil Bottles

Oil Inject Bottle

1. Determine the correct oil for the A/C

system being serviced.

2. Unscrew the lid from the oil inject

reservoir and remove the piston.

3. Fill the reservoir with oil only to the

MAX FILL line. Overfilling the reservoir
will compromise the o-ring seal and
may cause air to be injected into the
vehicle system.

4. Spread a thin film of oil on the piston o-ring (to

reduce seal drag), and insert the piston into the
reservoir. Thread the lid onto the reservoir.

5. Slowly push the piston into the reservoir until

you see oil at the connector.

6. Inspect the oil reservoir bottle to ensure there are

no air bubbles between the piston and the oil—
piston should be in direct contact with oil supply.

7. Hold the assembly by the plastic bottle, and

insert the connector into the magnetic coupler
on the unit.

8. Inspect the bottle again to ensure there are no air

bubbles between the piston and the oil—the piston
should be in direct contact with the oil supply.

Oil Drain Bottle

1. Hold the oil drain bottle by the plastic

bottle, and insert the connector into the
magnetic coupler on the unit.

Dye Inject

Oil Drain

Oil Inject

Oil Drain

Bottle

Oil Inject

Bottle

UV Dye

Inject Bottle

Magnetic Couplers

Advertising