9 manual fusion, Manual fusion – Levenhuk C800 NG Digital Camera, USB 2.0 User Manual
Page 60
Help Manual
52
9.9 Manual Fusion•••
Make sure that the
ToupView
package and
UCMOS
or
UHCCD
camera are correctly
installed. Turn on the microscope's light.
1. Run ToupView and start the camera;
2. Choosing
Setup>Manual Fusion•••
command or clicking on the toolbar will
bring up a dialog called “
Manual Fusion
”;
3. Use the microscope
coarse
or
fine
focus knobs to move the sample stage up and
down, in order to find the positions where the clearest regions of the whole sample
can be seen on the
Video
window;
4. Click
Capture
button to capture an image into the image list which will be used for
the fusion operation.
5. Unless there is more than one image is captured, the
Clear
buttons will not be
enabled. Unless there are more than two images being captured, the
Fusion
buttons
will not be enabled. If the captured images are not satisfactory, click the
Clear
button
to clear the captured images, and capture new images.
6. If enough images are captured, click
Fusion
to do the image fusion and the
Manual
Fusion
dialog will be closed automatically. If
Fusion
is clicked, please wait for some
time to get the final fusion result. The fused image will be displayed in a new active
Image
window and its title bar will be associated with a name of a digital by ToupView.
Clicking
Close
will end the
Manual Fusion
and return to the application area.
Note
:
1. Use the
coarse
and
fine
focus knobs to move the sample stage up and down;