Staub Electronics WPS-300-DVR-16CH WIREPATH - 16 CHANNEL DVR WITH 1TB HDD - Manual (Page 12)

12
WPS-300-DVR-9CH & 16CH Installation and Users Manual
3.2 CONNECTIONS
To ensure proper performance and operation of the 300 DVR, it is recommended that all connections
and setup be performed by a qualified system installer.
3.2.1 BASIC CONNECTIONS
• CAMERAS
Connect the video output from cameras or other composite video sources using coaxial cable to
the Video In connectors. Set each of the DIP switches to ON unless the corresponding video output
terminal is connected.
• MAIN MONITOR/VGA OUTPUT
Connect the Main Monitor BNC to a surveillance TV monitor
Connect the Main Monitor VGA output to a VGA monitor or Flat Panel TV
Connect the Main Monitor HDMI Output to HD Flat Panel TV.
Main Monitor Notes
1. For HDMI compatibility, confirm that the display will support a PC resolution of 1024x768 at 60 Hz. Some older TVs
and lower grade TVs do not support this resolution. Some model TVs only support this resolution on one of the HDMI
inputs. Check the manual for the specifications of the TV. A good indicator is a VGA connection on the TV.
2. The DVR will scale the image to the HDMI connection, this can cause the composite output (BNC) to “over-
scan” and cut off the edges of the image.
3. The HDMI connection must be connected prior to turning DVR on in order to sync with display.123
• POWER
Connect the included External Power Supply to surge protection or wall outlet.
3.2.2 OPTIONAL CONNECTIONS
• AUDIO INPUT
Connect the audio input connector to the audio line-out from line level microphones or other audio
sources. Please make sure to associate the audio inputs with a camera in the Camera Setup as described
in Section 6.2 accordingly. An audio input can only be associated with one camera.
• AUDIO OUTPUT
Connect the audio output connector to an amplifier and speakers.
• ALARM INPUTS
Connect the alarm inputs to NC and/or NO sensors or security alarm panel relays. Please make sure
to setup the alarm configurations as described in Section 6.3 accordingly.
• ALARM OUTPUT
Connect the alarm output to either a NC or NO type of device or system.
• ETHERNET
Connect the Ethernet connector to router via a standard Ethernet cable for control and streaming to an
Automation System, remote access via PC or Smartphone, or event email notifications.
Please make sure to setup the related configurations as described in Section 6.10 Network Setup.
Amplifier
Router
VGA HDM I ESATA ALARM OUT
G
G G
G
- + G RS-485 C
DC12V
POWER
WPS-300 Series DVR
Automation System
Motion Sensor(s)
Siren
LCD Monitor/Flat Panel TV
CRT Monitor
Camera(s)
Microphone
Speakers