Staub Electronics WPS-300-DVR-16CH WIREPATH - 16 CHANNEL DVR WITH 1TB HDD - Manual (Page 60)

60
WPS-300-DVR-9CH & 16CH Installation and Users Manual
• ZOOM ( ) +/-
Press these buttons on the front panel of the DVR or on the remote control to zoom the camera in or
out. Alternatively use the mouse to select the zoom icons.
Function
DVR Front Panel
and Remote
Control
Operations
Mouse Operation Descriptions
Focus
+/-
ENTER
• Use the +/- buttons to focus far/near
• Press the ENTER button to auto focus
Iris +/-
• Use the +/- buttons to increase/
decrease the Iris
• The Iris + button is used to access the
OSD control of Wirepath™ Surveillance
cameras and to confirm (enter)
commands
Auto Pan (3)
+/-
ENTER
*
#
Auto pan speed is shown in parenthesis
• Use the +/- buttons to increase/
decrease speed
• Press Enter start/stop Auto Pan
• Press (
*
) set start position
• Press (#) set end position
SEQ/Tour Mode
(5 sec.)
+/-, NUMBER
ENTER
SEQ dwell time is shown in parenthesis
• If SEQ mode is on, the camera will go to
preset position 0-9 (or 1-10) sequentially.
• Use the +/- and the Number buttons
to change dwell time
• Press the ENTER button to start/stop
SEQ mode
• An asterisk (
*
) will be shown if SEQ
mode is on
Preset (1)
+/-, NUMBER
ENTER
Preset location is shown in parenthesis
• Use the +/- and the Number buttons
to change Preset location
• Set Preset location
Pan Speed (3) +/-
Manual pan speed is shown in parenthesis
• Use the +/- buttons to increase/
decrease speed
7.1 OSD CONTROL FOR WIREPATH™ SURVEILLANCE CAMERAS
Wirepath™ Surveillance 500 and 700 series analog cameras offer remote control of the OSD (On Screen
Display) menu. This is achieved through the PTZ functions of the DVR. The cameras must be connected to
the RS485 terminals on the DVR and properly configured according to the camera manual. The DVR must
also be properly configured. Please refer to Section 3.2 Optional Connections for the connections, Section
6.1 Pre-Camera Setup to set the PTZ ID of each PTZ camera, and Section 6.9 RS-232/422/485 Setup to setup
the RS485 control port.