Staub Electronics WPS-300-DVR-16CH WIREPATH - 16 CHANNEL DVR WITH 1TB HDD - Manual (Page 24)

24
WPS-300-DVR-9CH & 16CH Installation and Users Manual
• CONNECT/DISCONNECT
If the backup device is disconnected (as shown in screen capture above), plug the USB device into the
USB 2.0 port and then press ENTER on the front panel of the DVR or on the remote control. Alternatively
use the mouse to click on the CONNECT button. If the device is already plugged in, press ENTER on the
front panel of the DVR or on the remote control to connect the device. Alternatively use the mouse
to click on CONNECT. It is recommended to select the DISCONNECT option before unplugging the
USB device.
Note 1: Before using a USB drive, please format it to FAT32 file system using Windows.
Note 2: The backup device must be connected by the system software before it can be used to read/
write. If it fails to connect, unplug the device and then plug the device into the USB port again.
Note 3: Some backup devices may have compatibility problems. See the list of tested devices below.
TESTED USB 2.0 DEVICES
• Macpower Alumni Prefect USB 2.0 - PF-U2MS
• Transcend JetFlash 150/V60 Series, JetFlash V33 8GB
• Apacer Handy Steno AH220
• Pretec i-Disk Wave 512M-Black
• Kingston DataTraveler USB Flash Driver(DTI/512FE)
• Kingston DataTraveler DT100 8GB
• SanDisk Cruzer micro USB Flash Driver
• Sandisk Cruzer Titanium 4GB, Cruzer Contour 4GB
• Sony MICRO VAULT Classic Series
• OCZ ATV 4GB, Rally2 4GB
TESTED DVD DRIVES
• Asus DRW-1608P Series
• Pioneer DVR-A11, DVR-X152 Series
• BenQ EW200G Series
• LITEON LightScribe DVD Writer SHM-165H6S, 20X DVD Writer DX-20A4P
• Sony DVD/CD Rewritable Drive Model DRX-810UL Series
• NEC DVD/CD Rewritable Drive Model ND-4550A Series
• HP dvd9404e External 18X Super Multi DVD Writer Series
• BACKUP
Once a device is connected, use the ▲▼◄► buttons on the front panel of the DVR or the remote control
to select BACKUP for the corresponding USB device and press ENTER. Alternatively use the mouse to select
this button. Enter the directory to backup the configurations to. This button will remain white in color and
unavailable until a USB device is connected.
• RESTORE
Once a device is connected, use the ▲▼◄► buttons on the front panel of the DVR or the remote control
to select RESTORE for the corresponding USB device and press ENTER. Alternatively use the mouse to select
this button. Enter the directory to restore the configurations from. This button will remain white in color and
unavailable until a USB device is connected.