Front and rear panels and remote control, 1 rear panel – Staub Electronics WPS-300-DVR-16CH WIREPATH - 16 CHANNEL DVR WITH 1TB HDD User Manual
Page 6
6
WPS-300-DVR-9CH & 16CH Installation and Users Manual
2. FRONT AND REAR PANELS AND REMOTE CONTROL
2.1 REAR PANEL
1. Video Input Connectors (1-9 on WPS-300-DVR-9CH, 1-16 on WPS-300-DVR-16CH)
Connect system cameras to these BNC connectors. The corresponding 75 Ω termination must be ON
unless the video output terminal is connected. See item 5 below.
2. Video Output Connectors (1-9 on WPS-300-DVR-9CH, 1-16 on WPS-300-DVR-16CH)
BNC connectors for looping camera output from the corresponding camera video input. The corresponding
75 Ω termination must be ON unless the video output terminal is connected. See item 5 below.
3. Audio Input Connectors (AUDIO IN 1-4)
RCA connectors for line-in audio signals supplied from external devices such as microphone amplifiers.
4. Audio Output Connectors (AUDIO OUT 1-2)
Supplies line-out audio signals to external devices such as amplifiers. Recorded audio will be supplied from
AUDIO OUT during playback.
5. 75 Ω termination
Set each of the DIP switches to ON unless the corresponding video output terminal is connected.
DIP Switches for setting the 75 Ω termination of the camera inputs for looping.
No Loop to Output- ON(Up)
Loop Output- OFF (Down)
6. Main Monitor Output Connectors (6a - BNC MAIN OUT, 6b - Y/C (S-Video) MAIN OUT)
Connection to TV monitors via mini-din S-video connector or BNC connector for main monitor display.
7. MAIN-AUX Connectors (MAIN-AUX IN/OUT)
Used to daisy-chain multiple DVR Monitor Outputs. MAIN-AUX OUT has the same output as MAIN OUT, but can
be switched to Main Aux Input through RS-232 control.
8. Cooling Fan
Internal power supply exhaust fan to provide cooling to the unit. When installing, please leave room behind
the unit in order to maintain a proper operating temperature.
9. Power Switch (POWER)
Main power for the unit.
NOTE: Before turning the power OFF, select SHUTDOWN from the MENU and allow time for the hard drives
to properly shutdown. Hard drive damage may occur if the unit is not shut down from the MENU.
10. Power Connection (DC IN)
Connect the supplied External Power Supply. Acceptable Range: 12V / 8.33A DC
1
3
5
4
2
16
17
18
19
20
15
6b
VGA
HDMI
ESATA
ALARM
OUT
G
G
G
G
-
+
G
RS-485
C
DC12V
POWER