Aiwa HV-FX9000U - Manual (Page 17)

ENGLISH
Preparing the remote control
Inserting the batteries
Caution
To prevent damage from leakage or explosion, follow
the descriptions below.
• Insert two supplied R03 (size AAA) batteries with the
0 and 9 marks correctly as illustrated.
• Do not mix old batteries with new ones or different
types of batteries.
• Do not throw the batteries into a fire, apply heat to
them or take them apart.
• Do not carry the batteries with keys or other metallic
objects.
Note
Remove the batteries when they have no more power, or when
you do not use the remote control for a long period of time.
Using the remote control
Point the remote control toward remote sensor.
Notes
• The remote control may not operate when there is any
obstruction between the remote control and remote sensor.
• Strong ambient light sources such as a fluorescent lamp or
direct sunlight may cause unreliable operation.
• Using a TV with the same type of infrared remote control
facing the same direction may cause incorrect operation.
• The maximum distance for effective control between the
remote control and remote sensor is 7 meters. When the
maximum operable distance becomes shorter, replace both
batteries with new ones.
• Although you can use the remote control within an angle of
up to 30 degrees in any direction from directly in front of
remote sensor, we recommend a narrower angle for stable
operation.
When a TV is connected with an antenna
cable
When the TV is connected to the RF OUT connector using a
supplied antenna cable, set the channel selector at the rear
to 3 CH or 4 CH, not employed for broadcasts, and select
the same channel on the TV.
(For watching the VCR, set channel 3 ch or 4 ch on the TV.)
To select a desired TV channel on the TV
Turn the TV on and turn off this VCR.
To see a TV program or video program selected on the
VCR
Turn the TV and VCR on, and press TV/VCR to display
VCR in the display window.
When a TV is connected with audio and
video cables
When the TV is connected using the supplied audio and
video cables, turn the TV and VCR on, and select the video
input mode on the TV.
VCR reception setting
When using the VCR, the signal passes from the antenna to
the VCR and then out to the TV. Before you use the VCR, a
video output channel must be set on your TV.
5 m
Remote sensor
TV/VCR
VCR
30
30
8
CONTINUE
AERIAL
(VHF/UHF)
RF OUT
3CH 4CH
3CH 4CH
7 m