Vanguard ATRT-03_03B - Manual (Page 33)

ATRT-03, ATRT-03A, AND ATRT-03B USER’S MANUAL REV 7
27
3.4 Enabling the Computer Interface
The ATRT-03 can be connected to a computer via the RS-232C interface port. In order to
remotely control the unit using the provided Transformer Turns Ratio Analysis (TTRA) software,
the unit must be placed in Computer Control mode. Follow the steps below to place the unit in
Computer Control mode:
a. Start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the [4] key (NEXT PAGE).
c. The following screen will be displayed:
Press the
[1]
key (COMPUTER CONTROL).
d. The following screen will be displayed:
You can now use the TTRA software to remotely control the unit from the PC. Please see
the software User’s Manual for further information.
Press the [STOP] key to abort Computer Control mode and return to the “START-UP”
menu.
COMPUTER ITF MODE
*** CAUTION! ***
CABLES MAY HAVE VLTG
“STOP” TO ABORT
1.COMPUTER CONTROL
2.SET TIME
3.SET TEST VOLTAGE
4.TEST PLANS
1.ENTER XFMR ID
2.REVIEW RECORD
3.RESTORE RECORD
4.NEXT PAGE
1.TEST XFMR 08/16/10
2.SETUP 08:14:58
3.CALCULATOR
4.DIAG 5.QUICK TST