ADTRAN 1202076L2 - Manual (Page 92)

Chapter 8. Telnet/Terminal Menus
8-4 TSU 600 User Manual 61202076L1-1
Editing the Temp Map
If further changes to the Temp Map are needed, do the following:
Applying the Temp Map
Once the Temp Map reflects the desired configuration, use selections 8
or 9 to apply this configuration to Map A or B, respectively.
Reviewing Maps
Selections 4 through 6 give a summary of the number of ports assigned
to Map A, Map B, and the Temp Map, respectively.
Step Action Explanation
1 Use selection 7 to enter
the Temp Map edit
mode. Upon entering this mode, the cursor
location moves to DS0 number one in the
DS0 field of the Temp Map.
The cursor may be moved from one DS0
to another by using the up and down
arrows until the cursor is located at the
DS0 number whose assigned port needs
to be changed.
2 Press the Enter key to
cause the cursor to move
into the
Port field.
The up and down arrows are then used
to scroll through the possible port selec-
tions.
3 Press the ESC key This restores the previous port assign-
ment and returns to the DS0 field.
4 Press the Enter key This saves the current selected port and
returns to the DS0 field.
Once the cursor is again located in the
Temp Map DS0 field, press the ESC key
a second time to return to selection 1
below the Temp Map display.