Yokogawa µR20000 - Manual (Page 72)

Commands
1
2
3
4
5
6
App
Index
IM 04P01B01-17E
4-29
MC Clears the message printout
buffer.
Syntax MC p1<terminator>
p1 Clear the message printout buffer (0)
Example Clear the message printout buffer.
MC0
VG Resets the report data of the
periodic printout.
Syntax VG p1<terminator>
p1 Operation type
2 Reset the report data of the periodic
printout.
Example Reset the report data of the periodic printout.
VG2
Description This setting is valid when the recorder is set to
print the report data using periodic printout.
YC Initializes settings.
Syntax YC p1<terminator>
p1 Initialization type
0 Initialize the Setting mode and Basic
Setting mode settings.
1 Initialize the Setting mode settings.
Example Initialize the Setting mode and Basic Setting
mode settings.
YC0
UY Stops the record position
adjustment.
Syntax UY p1<terminator>
p1 Fixed to 0.
Query UY?
Example Stop the record position adjustment.
UY0
Description Returns the execution status of the record
position adjustment in response to a query.
0: Stopped, 1: In progress
4.7 Output Commands
BO Sets the byte output order.
Syntax BO p1<terminator>
p1 Byte order
0 Outputs the data MSB first.
1 Outputs the data LSB first.
Query BO?
Example Output the data MSB first.
BO0
Description This command applies to the byte order of
numerical data during BINARY output.
CS Sets the checksum (/C3 option).
Syntax CS p1<terminator>
p1 Use/Not use the checksum
0 Not use
1 Use
Query CS?
Example Use the checksum.
CS1
Description This command can be used only on the RS-
422A/485 communication interface.
IF Sets the status filter.
Syntax IF p1<terminator>
p1 Status filter value
(0.0.0.0 to 255.255.255.255)
Query IF?
Example Set the status filter value to 1.0.4.0.
IF1.0.4.0
Description For details, see chapter 6.
Note
Initialization of BO/CS/IF Command Settings
• For serial communications
Settings entered using the BO/CS/IF commands revert to their
initial values when the recorder is reset (when the recorder is
power cycled, or the user exits the basic setting mode with the
YE command).
• Byte output order, checksum: 0
• Status filter: 255.255.255.255
If the recorder is reset, you must restore these settings.
• For Ethernet communications
Settings entered using the BO/IF commands revert to their
initial values when the connection to the recorder is cut. After
reconnecting the recorder, you must reenter the settings.
4.6 Control Commands/4.7 Output Commands