Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 15)

These RJ45 management ports are located together on the left side of the front panel on 24-port
models, and in the middle of the rear panel on 48P-port models.
1 Console port
2 Out-of-band management port
FIGURE 7 Management interfaces on 24-port models
1 Out-of-band management port
2 Console port
FIGURE 8 Management interfaces on 48P-port models
Console management interface
The console management interface is an RJ45 serial port that allows you to configure and manage the
device using a third-party terminal emulation application from a directly-connected PC.
Out-of-band management interface
The out-of-band management interface is an RJ45 port that allows you to configure and manage the
device from the network.
Reset button
The reset button allows you to restart the system without switching the power supplies off and on or
using the CLI or Web Management Interface. When the reset button is pressed, the system resets and
the software is reloaded. The reset button is located next to the PSU LED on both 24-port and 48-port
models.
Network interfaces for ICX 6610devices
ICX 6610-24, ICX 6610-24, ICX 6610-48, and ICX 6610-48P devices contain the following interfaces:
Console management interface
Brocade ICX 6610 Stackable Switch Hardware Installation Guide 13
53-1003082-02