Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 92)

In-band access
You can access the management agent in the switch from anywhere within the attached network using
Telnet, SSH, or other network management software. However, you must first configure the switch
with a valid IP address, subnet mask, and default gateway. If you have trouble establishing a link to
the management agent, check to see if you have a valid network connection. Then verify that you
entered the correct IP address. Also, be sure the port through which you are connecting to the switch
has not been disabled. If it has not been disabled, then check the network cabling that runs between
your remote location and the switch.
In-band access
90 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02