Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 66)

Devices running Layer 3 software
Before attaching equipment to a Brocade ICX 6610 switch, you must assign an interface IP address to
the subnet on which the router will be located. You must use the serial connection to assign the first IP
address. For subsequent addresses, you also can use the CLI through Telnet or SSH.
By default, you can configure up to 24 IP interfaces on each port, virtual interface, and loopback
interface. You can increase this amount to up to 64 IP subnet addresses per port by increasing the
size of the subnet-per-interface table.
The following procedure shows how to add an IP address and mask to a router port.
1. At the opening CLI prompt, enter enable.
device> enable
2. Enter the following command at the CLI Privileged EXEC level prompt, then press Enter. This
command erases the factory test configuration if still present:
device# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command
on a system you have already configured, the command erases the configuration. If you
accidentally do erase the configuration on a configured system, enter the write memory
command to save the running configuration to the startup-config file.
3. Access the global configuration level of the CLI by entering the following command:
device# configure terminal
device(config)#
4. Configure the IP addresses and mask addresses for the interfaces on the router.
device(config)# int e 1/1/2
device(config-if-e1000-1/1/2)# ip address 10.22.3.44 255.255.255.0
NOTE
You can use the syntax ip address ip-addr/mask-bits if you know the subnet mask length. In the
above example, you could enter ip address 10.22.3.44/24.
Syntax: enable [ password ]
Syntax: configure terminal
Syntax: [no] ip address { ip-addr ip-mask [ secondary ] | ip-addr/mask-bits [ secondary ] }
Use the secondary parameter if you have already configured an IP address within the same
subnet on the interface.
Configuring IP parameters for devices running Layer 3 software
This section describes how to configure IP parameters for devices running Layer 3 software.
Configuring IP addresses
You can configure an IP address on the following types of Layer 3 switch interfaces:
Devices running Layer 3 software
64 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02