Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 55)

Installing and replacing a power supply unit
CAUTION
Power supplies are hot swappable. Remove the power cord from a power supply before you
install it in or remove it from the device. Otherwise, the power supply or the device could be
damaged as a result. (The device can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power source.)
CAUTION
For the ICX 6610 devices, be sure that the airflow direction of the power supply unit matches
that of the installed fan tray. The power supplies and fan trays are clearly labeled with either a
green arrow with an "E", or an orange arrow with an "I."
You can run the device with one or two power supply units installed. If you install a second power
supply, it is recommended to install a second fan tray also.
Installing an AC power supply
NOTE
You need a #2 Phillips screwdriver and a flat-head screwdriver for installation.
Use the following steps to install an AC power supply in the switch.
FIGURE 42 Installing an AC power supply unit
1. If replacing a power supply, remove the previously installed power supply from the appropriate slot
by removing the two screws with a flat-head screwdriver.
2. If installing a new power supply into a slot covered with a filler panel:
a)
Using a Phillips screwdriver, unscrew the screws on the filler panel.
b) Remove the filler panel.
Installing and replacing a power supply unit
Brocade ICX 6610 Stackable Switch Hardware Installation Guide 53
53-1003082-02