Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 30)

Desktop installation
Use the following steps to install the ICX 6610 on a desktop or other flat surface.
FIGURE 18 Attaching the adhesive feet
1. Attach the four adhesive feet to the bottom of the first switch.
2. Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that
adequate ventilation is provided for the system. A 3 inch clearance is recommended on each side.
3. If installing a single switch only, refer to Powering on the system section.
4. If installing multiple switches, attach the adhesive feet to each one. Place each device squarely on
top of the one below, in any order.
Rack mount installation
NOTE
You will need a Phillips screwdriver for installation.
Before mounting the switch in a rack, pay particular attention to the following factors:
• Temperature: Because the temperature within a rack assembly may be higher than the ambient
room temperature, check that the rack-environment temperature is within the specified operating
temperature range.
• Mechanical loading: Do not place any equipment on top of a rack-mounted unit.
• Circuit overloading: Be sure that the supply circuit to the rack assembly is not overloaded.
• Grounding: Rack-mounted equipment should be properly grounded. Be sure to check supply
connections in addition to direct connections to the mains.
Desktop installation
28 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02