Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 86)

Console (serial RJ45) management port pinouts
Console serial RJ45 management port pinouts TABLE 18
Pin number Definition Notes
1 NC
2 NC
3 UART0_TX Console Port
4 GND
5 GND
6 UART0_RX Console Port
7 NC
8 NC
Cable specifications
The following table lists the specifications for the cables used with the 10G, 1G, 100Mb, and 10M
ports. For information about supported transceivers, see the Supported 10G SFP+ transceivers and
Supported SFP transceivers tables.
NOTE
Cable installation and network configuration will affect overall transmission capability. The numbers
provided below represent the accepted recommendations of the various standards. For network-
specific recommendations, consult your local Brocade reseller or system engineer.
Cable length summary TABLE 19
Cable
Type Connector Type Core
Diameter(microns) Modal
Bandwidth(MHz*km) or
Wavelength (nm) Range
(meters)
10GBase-ER MMF LC connector for
SFP+ module 9 125 40km
10GBase-LR SMF LC connector for
SFP+ module 9 125 10km
10GBase-
LRM MMF LC connector for
SFP+ module 62.5 200 220
MMF 50 500 220
Console (serial RJ45) management port pinouts
84 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02