Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) - Manual (Page 19)

The EZSwitchSetup wizard starts, as shown in the following figure.
FIGURE 4 EZSwitchSetup introduction window
Connecting cables
1. Choose the method of connecting to your LAN.
You have the choice of using a serial connection or an Ethernet connection to your LAN to set the
IP address for the switch. The Ethernet connection is generally more convenient and preferred.
Use the serial connection if it is not possible or not convenient to connect the host on the same
subnet as the switch.
2. Click Next.
Connecting cables
EZSwitchSetup Administrator’s Guide 17
53-1003129-01