Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) - Manual (Page 25)

Confirming IP addresses
The Confirm IP Address window as shown in the following figure is displayed after you have assigned
IP addresses, using either a serial connection or an Ethernet connection.
FIGURE 10 Confirm IP Address window
1. Check the displayed addresses carefully to be sure they are correct, then click Next.
The Continue Configuration? window is displayed as shown in the following figure.
2. Select one of the following continuation options:
• Continue setting up your target switch with EZManager
Select this option if you intend to use EZSwitchSetup Switch Manager as your primary
management program for this switch.
• Discover another switch on the same subnet for IP assignment only
Select this option to discover another switch and set the IP address.
If you select this option, EZSwitchSetup Switch Manager will not be the default management
tool for this current target switch. To set up EZSwitchSetup Switch Manager as the
Confirming IP addresses
EZSwitchSetup Administrator’s Guide 23
53-1003129-01