Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) User Manual
Page 24
Select this option only if a DHCP server is available on your network. When you click Next,
an IP address is automatically obtained from the DHCP server and the Confirm IP Address
window is displayed. Skip to
FIGURE 9 Set Switch IP Address window
NOTE
Beginning at
, the steps are the same for both serial and Ethernet connections.
5.
If you are setting up the switch for the first time, the addresses shown are not valid. If you click
Next with these addresses in place, EZSwitchSetup returns an error message.
To set up IPv4 addresses, edit the address information on the Set Switch IP Address window to
create static addresses appropriate for your LAN connection.
To set up IPv6 addresses, enter the IPv6 address and prefix in the spaces provided.
6.
Click Next.
EZSwitchSetup attempts to log in using default credentials. If you have already changed your
admin password, you will be prompted to enter your new password.
on page 23.
Setting Up Your Switch
22
EZSwitchSetup Administrator’s Guide
53-1003129-01