HATZ Diesel 1B 50 - Manual (Page 31)

CAUTION
Exceeding of the permissible forces at the speed control
lever and stop pin can cause damage to the stops and in-
side regulator parts.
Please note the following figure.
Max. permissible forces on the speed control lever
F < 15 N STOP
76.5°
STOP
F 30 N
M Nm
<
<
START
2.3
7.2 Performing tests
Before starting
Before starting the engine, several tests need to be performed to ensure the
machine is working properly.
Procedure
Step Test
1 The machine is standing securely and on a level surface.
2 The installation location is adequately ventilated.
3 There is a sufficient amount of fuel in the fuel tank (see the chap-
ter 4.2 Fuel, page 24).
4 There is a sufficient amount of engine oil in the engine housing
(see the chapter 4.3 Engine oil, page 24).
5 The starter rope of the recoil start does not exhibit abrasion
(hand start).
6 The oil bath filter (option) is filled with engine oil (see the chapter
7.8.2 Oil level in the oil bath filter (option), page 46).
1B20, 1B27, 1B30, 1B40, 1B50 Operation and use
HATZ Operator's Manual 1B20-1B50 31