HATZ Diesel 1B 50 - Manual (Page 37)

NOTICE
i
▪ If the engine stops again immediately after starting, or stops
independently during operation, this is an indication that a
monitoring element of the automatic shutoff has been acti-
vated.
▪ Remedy the malfunction before further starting attempts
(see the chapter 9.1 Troubleshooting, page 77).
▪ Despite the automatic shutoff, check the oil level every 8-15
operating hours (see the chapter 7.8 Checking the oil level
and adding oil if necessary, page 44).
▪ If the fuel shutoff valve (additional equipment) is blocked
due to an electrical fault of the fuel supply and the engine
therefore does not start, an emergency start can be carried
out (see the chapter 9.2 Emergency start, page 83).
7.5 Switching off the engine
Procedures
The engine can be switched off in different ways depending on how it is
equipped:
▪ Speed control lever (mechanical)
▪ Stop pin (mechanical)
▪ Starting key (electrical)
7.5.1 Switching off the engine (mechanical)
NOTICE
i
Engines with a blocked lower idle speed cannot be switched off
with the speed control lever. In this case, the engine is switched
off with the stop pin or starting key, depending on how the en-
gine is equipped.
1B20, 1B27, 1B30, 1B40, 1B50 Operation and use
HATZ Operator's Manual 1B20-1B50 37