Configuring email, 9 configuring email – LT Security LTN7600 Series NVR (V2.2.3) User Manual
Page 149
User Manual of DS-9600/8600/7700/7600 Series NVR
149
4. Enter the Server Port and HTTP Port in the text fields. The default Server Port is 8000 and
the HTTP Port is 80, and you can change them according to different requirements.
5. Click
to save and exit the interface.
Note:
The Server Port should be set to the range of 2000-65535 and it is used for remote client software access.
The HTTP port is used for remote IE access.
9.2.9 Configuring Email
Purpose:
The system can be configured to send an Email notification to all designated users if an alarm
event is detected, etc., an alarm or motion event is detected or the administrator password is
changed.
Before configuring the Email settings, the NVR must be connected to a local area network (LAN)
that maintains an SMTP mail server. The network must also be connected to either an intranet or
the Internet depending on the location of the e-mail accounts to which you want to send
notification.
Steps:
1.
Enter the Network Settings interface.
Menu >Configuration> Network
4.
Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the
Network Settings menu, as shown in Figure 9. 18.
Figure 9. 18 Network Settings Interface
5.
Click
to save the settings.
6.
Select the Email tab to enter the Email Settings interface.