LT Security LTN8600 Series NVR (V2.3.2) - Manual (Page 131)

User Manual of 9600/8600/7700/7600 Series NVR
131
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
9600/R/X and 8600
7700/7600
7700/7600S-P8
Figure 9. 1 Network Settings Interface
Note: Dual-NIC configuration is only applicable for 9600/R/X and 8600 series NVR.
3. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.