LT Security LTN8600 Series NVR (V2.3.2) User Manual
Page 37
User Manual of 9600/8600/7700/7600 Series NVR
37
Explanation of the icons
Edit basic parameters of the camera
Delete the IP camera
Get the live view of the camera
Configuring the customized protocols
Purpose: To connect the network cameras which are not configured with the standard protocols, you can configure
the customized protocols for them.
Steps:
1.
Click the Protocol button to enter the protocol management interface.
Figure 2. 16 Protocol Management Interface
2.
There are 16 customized protocols provided in the system, you can select one and configure its
corresponding parameters.
Note:
Before customizing the protocol for the network camera, you have to contact the manufacturer of the
network camera to consult the URL (uniform resource locator) for getting main stream and sub-stream.
Example: The format of the URL is: [Type]://[IP Address of the network camera]:[Port]/[Path]. E.g.,
rtsp://192.168.1.55:554/ch1/main/av_stream.
Protocol Name: Edit the name for the custom protocol.
Enable Substream: If the network camera does not support sub-stream or the sub-stream is not needed,
leave the checkbox empty.
Type: The network camera adopting custom protocol must support getting stream through standard RTSP.
Transfer Protocol: Select the transfer protocol for the custom protocol.
Port: Set the port No. for the custom protocol.
Path: Set the resource path for the custom protocol. E.g., ch1/main/av_stream.
3.
Click the Apply button to save the settings and click OK to finishing customizing the protocol.
After adding the customized protocols, you can see the protocol name is listed in the dropdown list, please refer to