LT Security LTN8600 Series NVR (V2.3.2) - Manual (Page 138)

User Manual of 9600/8600/7700/7600 Series NVR
138
4. Configure the following SNMP settings:
•
Trap Address: IP Address of SNMP host.
•
Trap Port: Port of SNMP host.
5. Click to save and exit the interface.
Note: Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and
exception message to the surveillance center.
9.2.5 Configuring Remote Alarm Host
Purpose:
With a remote alarm host configured, the NVR will send the alarm event or exception message to the host when an
alarm is triggered. The remote alarm host must have the Network Video Surveillance software installed.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 15.
Figure 9. 15 More Settings Interface
3. Enter Alarm Host IP and Alarm Host Port in the text fields.
The Alarm Host IP refers to the IP address of the remote PC on which the Network Video Surveillance
Software (e.g., NVMS7000) is installed, and the Alarm Host Port must be the same as the alarm
monitoring port configured in the software.
Figure 9. 16 Configure Alarm Host
4. Click to save and exit the interface.
9.2.6 Configuring Multicast
Purpose:
The multicast can be configured to realize live view for more than 128 cameras through network for 9600/R/X
series NVR. And for 8600/7700/7600 NVR, using the multicast function, more than 64 cameras are connectable.
A multicast address spans the Class-D IP range of 224.0.0.0 to239.255.255.255. It is recommended to use the IP