LT Security LTN8600 Series NVR (V2.3.2) - Manual (Page 43)

User Manual of 9600/8600/7700/7600 Series NVR
43
3.2 Operations in Live View Mode
In live view mode, there are many functions provided. The functions are listed below.
•
Single Screen: showing only one screen on the monitor.
•
Multi-screen: showing multiple screens on the monitor simultaneously.
•
Auto-switch: the screen is auto switched to the next one. And you must set the dwell time for each screen on
the configuration menu before enabling the auto-switch.
Menu>Configuration>Live View>Dwell Time.
•
Start Recording: normal record and motion detection record are supported.
•
Output Mode: select the output mode to Standard, Bright, Gentle or Vivid.
•
Playback: playback the recorded videos for current day.
•
Aux/Main output switch: the NVR checks the connection of the output interfaces to define the main and
auxiliary output interfaces. The priority level for the main and aux output is HDMI>VGA>CVBS. This
means if the HDMI is used, it will be the main output. If the HDMI is not used, the VGA output will be the
main output. See the table below.
Table 3. 2 Priorities of Interfaces
HDMI VGA CVBS Main output Auxiliary
output
1 √ √ √ HDMI VGA
2 √ × √ HDMI CVBS
3 × √ √ VGA CVBS
4 Ч Ч √ CVBS
 √ means the interface is in use, × means the interface is out of use or the connection is invalid. And the
HDMI, VGA and CVBScan be used at the same time.
When the aux output is enabled, the main output can‟t do any operation, and you can do some basic operation on
the live view mode for the Aux output.
Note: For 7600S-P8, there is only one audio output, the VGA output has a higher priority over CVBS output.
When you enable the audio in both the CVBS and VGA audio output, the audio from the audio out interface is for
VGA.
3.2.1 Front Panel Operation on Live View
Table 3. 3 Front Panel Operation in Live View
Functions Front Panel Operation
Show single screen Press the corresponding Alphanumeric button. E.g. Press 2 to display only the screen
for channel 2.
Show multi-screen Press the PREV/FOCUS- button.
Manually switch
screens
Next screen: right/down direction button.
Previous screen: left/up direction button.
Auto-switch Press Enter button.
Playback Press Play button.