Rhino Shelter DOMED-40W X 60L X 18H User Manual
Page 15
43
16A
The door dropping tube assembly
23
22
22A
23A
14
16D
41
37
Installation of mechnical door
(Seeing from inside)
16B
31A
15
15B
Figure 18 Installation of the Mechanical Door
MECHANICAL DOOR INSTALLATION STEPS
1. Install Main Door Pulleys (left and right) over the
Top of the Door on each side of the Door Beam (Part
#43). Use M10x75 Bolts and Nuts (Part #29).
2. Next mount the Winch Mechanism to the Front
Panel Lower Beam (Part #16D). Mechanism should line
up with pocket in Fabric Front Side Panel. Use
M10x75Bolts and Nuts (Part #29).
3. Slide Bottom Door Dropping Tube (Part
#23&23A) into the bottom horizontal fabric pocket
on the Door Cover (Part #37). Then slide the six
remaining Door Dropping Tubes (Part #22&22A)
into the remaining horizontal fabric pockets in the
Door Cover (Part #37) and use the M5x10 Self-
Assembly Instructions 40x60x18 Domed Style Truss Building
ASSEMBLE MECHANICAL DOORS
Step #13 - Install Main Doors, Cover, and Opener
Start securing the side covers at the bottom and
work up towards the top. At the bottom of the panel,
use one of the ropes provided to lace the fabric to the
Lower Side
Panel Beam (Part #15A). A separate fabric cover
above Front and Rear Door Panel (Part #35) is
provided.
Main Cover Edge Tie Off - Once both Front and Rear
Panel Covers are installed, the Main Cover Edge flap,
front and rear, should be tightened and tied off. Begin
by pulling the remaining Main Cover Material over the
Frame arch, so the rope pocket is over the edge of the
frame. Tie off the rope that goes through the rope
pocket on one side. The rope ties off to the loop that is
located on the Base Plate Corner (6L or 6R). Moving
to the other side, begin to pull the rope down. Hold the
rope in hand, and push down at the bottom of the rope
with a foot. Pull the rope tight, and tie off to the
welded hoop on the Base Plate. As you are pulling the
edge rope, it will be necessary to adjust the excess
material that will collect along the rope packet. Adjust
the material so that it is not bunched up and it does not
pull the main cover to one side or the other. Once the
Front is completed, repeat the process on the Rear flap
of the Main Cover.
14
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070