Rhino Shelter DOMED-40W X 60L X 18H - Manual (Page 16)

16
tapping screws (31A) to secure the door cover to
the dropping tube.
Assembly Instructions 40x60x18 Domed Truss Style Portable Building
Winch Assembly Mounted To rail
5. Next install the steel wire that leads from the door
winching assembly to the bottom of the door dropping
tubes. The Winch Assembly has a long and a short steel
cable secured to it. Feed the end of the shorter of the
two cables through the lower roller of the double pulley
at the top of the door assembly track closest to the
Winch Assembly, and then down through the holes in
the Bottom Door Dropping Tube (23,23A) on the left
hand side of the door (facing from the inside). When the
steel cable goes down though the hole in the Bottom
4. From the bottom of the door tracks (15,15B),
gently raise and slide one door dropping tube (22,22A)
into the tracks. And then feed the other remaining door
dropping tubes (22,22A,23,23A) into the door tracks.
Dropping Tube (23,23A), tie a knot in the steel wire
so that it cannot pass back up through the hole.
6. From the Winch Assembly route leading
end of the Longer Steel Cable through the
Upper Roller of the double pulley near door
track and then through the Single Roller on the
door track farthest from the Winch Assembly.
Then down through the Bottom Door Dropping
Tube (23,23A). When the steel cable goes
down though the hole in the Bottom Door
Dropping Tube, tie a knot in the steel cable.
Door can now be opened or closed by
operating the Winch Assembly. Raise and
lower the door several times to be certain door
tube ends are not binding on track. Lubricate if
necessary. Door Tubes Inserted Into Door Track
Double Pulley Nearest Winch Assembly
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070