Rhino Shelter DOMED-40W X 60L X 18H - Manual (Page 3)

M10x75 Hexagon Bolt, washer, nuts(29). Only snug up
Assembly Instructions 40x60x18 Domed Style Truss Building
3
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
drained away rather than accumulate and pool around
the unit.
Check to be certain that adequate clearance is allowed
for entry and exit.
When selecting a location for the building, consideration
should be taken of the ability of the ground to keep the
base Plates in place, as well as support the weight of the
building and content. Using the stakes and string,
measure off and square area for intended installation.
Level the ground as best as possible. A properly leveled
frame yields maximum strength.
Arches slide together at ends and secure using
Hexagon Bolts (Part #29) and Nuts
ARCH ASSEMBLY
Unit consists of One Front Arch, Five (5) Interior Arches,
and One Rear Arch. Assemble each arch on ground.
Begin by laying out the components of the Front and
Rear Arches. Front and Rear Arches consist of:
One (1) Top Ridge Tube (Part #1A)
Two (2) Front Wall Curved Roof Tube (Part #2A)
Two (2) Front Wall Sidewall Tubes with Wind Brace
supports (Part #3A)
Two (2) Sidewall Tubes (Part #4A)
Two (2) Corner Base Plates (Part #6L/6R)
Figure 2
Components slide into each other at the ends as shown
in diagram on page 3. Sidewall tubes (3A) must be
faced so the clips for Wind Brace Supports are facing to
the next interior arch. Secure them together using
nuts, do not over tighten nuts.
Use Hexagon Bolts with Washers and Nuts through pre-
drilled holes in frame members. Be certain to insert
Hexagon Bolts from the outside into the interior of the
unit, with the washers and nuts on the inside of the
frame. This will prevent the bolts from puncturing
through the cover material. Do not tighten down the nuts
completely until frame is fully assembled and set in
place.
Arches #2 and #6 include:
One (1) Top Ridge Tube (Part #1)
Two (2) Curved Roof Tube (Part #2B)
Two (2) Curved Shoulder Tube (Part #3B)
Two (2) Sidewall Tubes (Part #4)
Two (2) Base Plates (Part #8A/8B)
Figure 3