Rhino Shelter DOMED-40W X 60L X 18H - Manual (Page 9)

Wall. See Figures 12 and 13.
framework. See Figures 12 and 13. Also assemble
Assembly Instructions 40x60x18 Domed Style Truss Building
9
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Figure 11
Use Bolt M10X30 (Part #30) at the end of each Wind
Brace Support to secure. Check level of arch upright
before final tightening of Wind Brace Clip (Part #17A).
Slide clips as needed on Arch Sidewall until Arch is level
and plumb.
Continue to install Interior Arch Assemblies #3, #4, and
#5, in the same manner. Overlap pinched ends of Purlin
Horizontal Cross rails onto same carriage bolts inside
frame assembly.
Install Interior Arch #6 (next to Rear Arch), with the Wind
Brace Support Tabs on the Base Plates (Part #8A)
facing the Rear End Arch. Install Rear End Arch into
Base Plate Sockets. Install final Cross Rails (Purlin
Horizontal Tubes) and Wind Cross Brace Assemblies as
described above. Check end Arch for plumb before
securing the Wind Brace bolts tight.
Next check entire frame assembly for square and plumb.
Adjust Wind Braces and Cross Rails (Purlin Horizontal
Tubes) as necessary to being frame into plumb. Next
tighten frame bolts adequately. DO NOT over tighten
bolts so as to oval or compress frame components.
ERECTING END WALL SUPPORTS
Step #5 –Assemble End Wall Framing
Each end wall consists of vertical and horizontal beams
to form a framework to support Mechanical Door and
End Panels. Four vertical beams extend from bottom of
arch assembly to base plates. The vertical Door Track
Beams go in the center positions. The vertical side
beams are on each side of the Door Track Beams. The
horizontal beams consist of the Door Beam across the
top, two horizontal Side Beams, and lower horizontal
rails for the cover panel tensioning.
Begin by assembling Door Track Beams from Upper
Door Track (#14) and Lower Door Track (#15). Lower
Door Track goes into Base Plate (#7), and Upper Door
Track secures to Curved Roof Arch. Repeat for each
side of Door.
Next secure horizontal Door Beam (#43) between
vertical Door track Beams. Insert and assemble Vertical
Support Tube for Door beam (#43A) from the Center of
Door Beam (#43) to Top Roof Tube (#1A).
Assemble Vertical Side Beam for End of unit from Upper
Side Panel Beam (#14A) and Lower Side Panel Beam
(#15A) on side of door beams. Repeat for each side (left
and right) of end. Base of Side Panel Beam goes into
Base Plate (#7) and secures to Curved Roof Tube (#2A)
at top.
Horizontal members, which connect edge of Arch
Assembly to Vertical Door Track Beams and vertical
Side Beams are made from Middle Lower Rail parts
#16B and #16C. These bolt between Door Track Beam
and Side Beam Assemblies on each side to complete
Upper Horizontal Side Rail (#16A) on each side.
Bottom horizontal rails are the Cover Tensioning Tubes
(#18). Secure one between Arch Assembly and vertical
Side Beam, and another between vertical Side Beam
and vertical Door Track. Repeat for each side of End
The Rear Wall Assembly is identical. Repeat assembly
process for rear end assembly to prepare for door
installation.
.