Avaya 4600 - Manual (Page 33)

Issue 2 July 2006 33
NVVPNAUTTYPE 2 This parameter is valid when
NVVPNCFGPROF is set to 1
(Avaya security gateway). If the
Avaya security gateway software
version is 4.0 or higher, the
default value does not need to be
changed.
Controls user authentication
mode. Valid value is one ASCII
numeric digit, 1 and 2. Values are:
1 = CHAP
2 = PAP
The method chosen is
dependent on the type of
authentication used by the
security device.
To set the device authentication
type to CHAP, use the following
command:
SET NVVPNAUTHTYPE 1
NVSGIP
“” (Null) This parameter controls the
primary IP address or the fully
qualified domain name of the
security device.
Valid values are zero or more IP
Addresses in dotted-decimal or
fully qualified domain name
format, separated by commas
without any intervening spaces
(0 to 255 ASCII characters,
including commas). Null (“”) is a
valid value, but the value may
not contain spaces.
This value cannot be more than
30 characters.
To set the device primary IP
address to 10.1.1.1, use the
following command:
SET NVSGIP 10.1.1.1
To set the device fully qualified
domain name to
primarysg.mycompany.com, use
the following command”
SET NVSGIP
primarysg.mycompany.com
Table 5: VPNremote for 4600 Series IP Telephones Customizable System
Parameters (continued)
Parameter Name Default
Value Description and Value Range Example
3 of 15